How To Install A Washing Machine Box Right After Sheetrock Is Installed

1

Use a stud finder to find two adjacent framing studs inside the wall behind the washing machineHow to Install a Washing Machine Box immediately after Sheetrock Is Installed. Mark the locations of the studs at the desired height of the washing machine box having a pencil. Ensure the marks are on the center-lines of each stud.

2

Cut via the drywall in amongst the studs with a utility knife using the pencil marks as a guide. Get rid of the section of drywall without damaging it, as it will be reused once the washing machine box has been installedHow to Install a Washing Machine Box soon after Sheetrock Is Installed.

3

Unsnap and eliminate the outer trim surround from the front of the washing machine box. Position the box inside the cut-out section of wall so that the nailing fins on a single from the vertical sides of the box is flush with all the wall stud you wish to mount the box to. Ensure the outer edge of the box is flush using the surface of the drywall. Secure the box Clear Away Washing Machine Smells towards the stud by driving eight penny nails via the nail holes and in to the stud.

4

Nail a strap bracket -- if supplied with your brand of box -- horizontally in between bestwashingmachinex.com the two studs at the best and bottom in the box with eight penny nails, as this will secure the vertical side of the box that is not affixed to a wall stud.

5

Cement the hot and cold water supply lines and also the drain line for the fittings on the underside of the box with PVC pipe cement as per the instructions that came with all the box. Note that you may well have to remove a knock-out plug from the underside of the box using a flat blade screwdriver before installing the drain line.

6

Trim the original piece of drywall that you removed previously using a utility knife so that it will fit around the washing machine box. Screw the piece back into location with drywall screws driven in using a power drill that has a Phillips bit installed.

7

Apply drywall compound to the edges of the drywall where is was cut with a putty knife. Sand the compound smooth once it dries and paint the region to match the surrounding wall. Push the outer trim surround onto the washing machine box till it snaps into location.